Hi everybody!
Roasting Brazilian beans I saw it took 5 minutes before the beans started moving. Than they moved for about 30 secs and then they stopped moving. At 7 minutes (1,5 min later) they started again. I saw some black beans and were afraid the roast was spoiled. However, the endresult looked quite good. Four black beans but the others looked ok. I think 5 minutes is too long to lay still, so I think I will adjust the profile (copy of it, of course). But ... looking at KL-Studio I see a lot of parameters ... I think it is best to increase the fan speed at the beginning, but I also think it's a good idea to ask the people with a lot of experience ... you!
If anyone can respond to this, I appreciate it a lot!
Thanks in advance!
Grtz from the Netherlands, Hans.
Where to start adjusting
- kaffelogic
- Site Admin
- Posts: 508
- Joined: Thu 18 Oct, 2018 9:38 am
- x 74
- Contact:
Re: Where to start adjusting
Have you recently replaced an old mesh chaff collector with a new glass chaff collector? If so, there is a calibration adjustment you will need to make.
Re: Where to start adjusting
I have the glass chaff collector since december or so. Lately I had a repair on my KL (new motor) and have the boostkit since a few weeks. I checked the calibration, but is was already on 1.05 (I read somewhere not to go any higher).kaffelogic wrote: ↑Sat 29 Apr, 2023 5:46 am Have you recently replaced an old mesh chaff collector with a new glass chaff collector? If so, there is a calibration adjustment you will need to make.
Any ideas?
Re: Where to start adjusting
Hi everybody!
In the mean time my Nano has been repaired by Roast Rebels and Kaffelogic. There was a technical problem (can happen) and they fixed it perfectly!
Happy roasting again!
In the mean time my Nano has been repaired by Roast Rebels and Kaffelogic. There was a technical problem (can happen) and they fixed it perfectly!
Happy roasting again!
-
- Posts: 1
- Joined: Fri 22 Sep, 2023 4:18 pm
Re: Where to start adjusting
How is the calibration done? Does it go by another name/setting? Does it apply to recent 120v machines sold to North American customers? Does it apply to Kaffelogic Studio? Is there a default value? My roaster was purchased with the Boost kit. How will we know if the adjustment has already been applied?kaffelogic wrote: ↑Sat 29 Apr, 2023 5:46 am Have you recently replaced an old mesh chaff collector with a new glass chaff collector? If so, there is a calibration adjustment you will need to make.
Thank you!